Configuring The Tcp Server; Configuring The Tcp Client - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Pre-configuration Tasks
Before configuring the TCP test, configure reachable routes between the NQA client and the
TCP server.
Data Preparation
To configure the TCP test, you need the following data.
No.
1
2
3
4

6.12.2 Configuring the TCP Server

The IP address and number of the port monitored by the server must be identical with those
configured on the client.
Context
Do as follows on the NQA server (TCP server):
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa-server tcpconnect [ vpn-instance vpn-instance-name ] ip-address port-number
The TCP monitoring service is configured.
----End

6.12.3 Configuring the TCP Client

This part describes how to set TCP test parameters.
Issue 03 (2010-09-20)
Data
Administrator name and test name
IP address and port number monitored by the TCP server
(Optional) Destination port numbers of the probe packets sent by the TCP client and
source IP addresses , source port numbers of test packets, interval for sending test
packets, and percentage of the failed NQA tests
Start mode and end mode of the test
NOTE
Note that the IP address and port number monitored by the server should be consistent with those configured
on the client.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
6-31