Huawei Quidway S9300 Configuration Manual - Network Management page 426

6 NQA Configuration
l
Procedure
Step 1 Configure a dynamic single-hop PW.
Configure a dynamic single-hop PW on the MPLS backbone network.
For the detailed configuration procedure, see "PWE3 Configuration" in the Quidway S9300
Terabit Routing Switch Configuration Guide - VPN.
Step 2 Configure a PWE3 Ping test of the single-hop PW.
# Configure PE-A.
<PE-A> system-view
[PE-A] nqa test-instance test pwe3ping
[PE-A-nqa-test-pwe3ping] test-type pwe3ping
[PE-A-nqa-test-pwe3ping] local-pw-id 100
[PE-A-nqa-test-pwe3ping] local-pw-type vlan
[PE-A-nqa-test-pwe3ping] label-type control-word
Step 3 Perform the test.
[PE-A-nqa-test-pwe3ping] start now
Step 4 Verify the test result.
After running the display nqa results command on the PE device, you can see that the test is
successful.
[PE-A-nqa-test-pwe3ping] display nqa results
NQA entry(test, pwe3ping) :testFlag is inactive ,testtype is pwe3ping
1 . Test 1 result
----End
Configuration Files
l
6-206
IP address of the remote peer
The test is finished
Send operation times: 3
Completion:success
Attempts number:1
Disconnect operation number:0
System busy operation number:0
Operation sequence errors number:0
Min Positive Jitter: 0
Max Positive Jitter: 0
Positive Jitter Num: 0
Positive Jitter Sum: 0
Positive Jitter Square Sum: 0
Packet Loss: 0
Destination ip address:10.2.2.2
Min/Max/Average Completion Time: 60/110/86
Sum/Square-Sum Completion Time: 260/23800
Average Single-Way Completion Time: 30
Last Good Probe Time: 2008-9-29 14:35:43.2
Configuration file of CE-A
#
sysname CE-A
#
vlan batch 110
#
interface Vlanif110
ip address 100.1.1.1 255.255.255.0
#
interface GigabitEthernet1/0/0
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Receive response times: 3
OverThresholds number: 0
Drop operation number:0
Operation timeout number:0
Connection fail number:0
RTT Stats errors number:0
Min Negative Jitter: 0
Max Negative Jitter: 0
Negative Jitter Num: 0
Negative Jitter Sum: 0
Negative Jitter Square Sum: 0
Packet Loss Ratio: 0
Issue 03 (2010-09-20)