Establishing The Configuration Task; Configuring Traceroute Test Parameters - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6.10.3 Checking the Configuration
After configuring the traceroute test, you can view the test result.

6.10.1 Establishing the Configuration Task

Before configuring a traceroute test, familiarize yourself with the applicable environment,
complete the pre-configuration tasks, and obtain the required data. This can help you complete
the configuration task quickly and accurately.
Applicable Environment
The NQA Traceroute test has a similar function with the tracert command except that the output
of the Traceroute test is more detailed.
Pre-configuration Tasks
Before configuring the Traceroute test, configure reachable routes between the NQA client and
the device to be tested.
Data Preparation
To configure the Traceroute test, you need the following data.
No.
1
2
3
4

6.10.2 Configuring Traceroute Test Parameters

This part describes how to set traceroute test parameters.
Context
Do as follows on the NQA client:
Procedure
Step 1 Run
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
Issue 03 (2010-09-20)
Data
Administrator name and test name
Destination IP address
(Optional) VPN instance name, maximum hops, initial TTL and maximum TTL value
of the packet, and source IP address and destination port of the packet
Start mode and end mode of the test
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
6-25