Enabling The Lsp Trap Function; Configuration Examples; Example For Configuring Static Lsps - Huawei AR1200 Series Configuration Manual - Mpls

Huawei AR1200 Series Enterprise Routers
Configuration Guide - MPLS
Procedure
l
l
----End

1.4.2 Enabling the LSP Trap Function

By configuring the trap function on an LSP, you can notify the NMS of the changes in the LSP
status.
Context
Run the following commands in the system view to notify the Network Management System
(NMS) of LSP status changes.
By default, the trap function is disabled during the setup of the LDP LSP.
Procedure
l
----End

1.5 Configuration Examples

The following sections provide several examples of the static LSP configurations. Familiarize
yourself with the configuration procedures against the networking diagram. Each configuration
example consists of the networking requirements, configuration precautions, configuration
roadmap, configuration procedures, and configuration files.

1.5.1 Example for Configuring Static LSPs

This section provides an example for configuring a static LSP.
Issue 01 (2011-12-30)
Run:
ping lsp [ -a source-ip | -c count | -exp exp-value | -h ttl-value | -m
interval | -r reply-mode | -s packet-size | -t time-out | -v ]
address mask-length [ ip-address ] [ nexthop nexthop-address | draft6 ]
MPLS ping is performed.
If draft6 is specified, the command is implemented according to draft-ietf-mpls-lsp-
ping-06. By default, the command is implemented according to RFC 4379.
Run:
tracert lsp [ -a source-ip | -exp exp-value | -h ttl-value | -r reply-mode | -
*
t time-out ] ip destination-address mask-length [ ip-address ] [ nexthop
nexthop-address | draft6 ]
MPLS tracert is performed.
If draft6 is specified, the command is implemented according to draft-ietf-mpls-lsp-
ping-06. By default, the command is implemented according to RFC 4379.
Run the snmp-agent trap suppress feature-name lsp trap-name { mplsxcup |
mplsxcdown } trap-interval trap-interval [ max-trap-number max-trap-number ]
command in the system view to enable the trap function for the LDP LSP and enable the
debugging of excessive mplsxcup or mplsxcdown information.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 Static LSPs Configuration
*
ip destination-
7