Figure 6-11 Networking Diagram For Configuring The Udp Test - Huawei Quidway S9300 Configuration Manual - Network Management

6 NQA Configuration

Figure 6-11 Networking diagram for configuring the UDP test

SwitchA
Configuration Roadmap
1.
2.
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Configure reachable routes between Switch A and Switch B, between Switch A and Switch C,
and between Switch B and Switch C. The configuration details are not mentioned here.
Step 2 Configure the NQA server on Switch C.
# Configure the IP address and UDP port number monitored by the NQA server.
<SwitchC> system-view
[SwitchC] nqa-server udpecho 10.2.1.2 6000
Step 3 # Configure Switch A.
# Enable the NQA client and create a UDP Public test.
<SwitchA> system-view
[SwitchA] nqa test-instance admin udp
[SwitchA-nqa-admin-udp] test-type udp
[SwitchA-nqa-admin-udp] destination-address ipv4 10.2.1.2
[SwitchA-nqa-admin-udp] destination-port 6000
Step 4 Perform the test.
[SwitchA-nqa-admin-udp] start now
Step 5 Verify the test result.
[SwitchA-nqa-admin-udp] display nqa results test-instance admin udp
NQA entry(admin, udp) :testflag is inactive ,testtype is udp
1 . Test 1 result
6-158
GE1/0/0 GE1/0/0
VLANIF100 VLANIF100
10.1.1.1/24 10.1.1.2/24
Configure Switch A as the NQA client and configure Switch C as the NQA server.
Configure the monitoring port number on the NQA server and create an NQA UDP Public
test on the NQA client.
Host address of the server
Port number used to monitor the UDP service on the server
The test is finished
Send operation times: 3
Completion:success
Attempts number:1
Disconnect operation number:0
System busy operation number:0
Operation sequence errors number:0
Destination ip address:10.2.1.2
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
SwitchB
GE2/0/0
VLANIF110 VLANIF110
10.2.1.1/24 10.2.1.2/24
Receive response times: 3
RTD OverThresholds number: 0
Drop operation number:0
Operation timeout number:0
Connection fail number:0
RTT Stats errors number:0
SwitchC
GE1/0/0
NQA Server
Issue 03 (2010-09-20)