Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Data Preparation
To configure the ICMP test, you need the following data.
No.
1
2
3
4
6.5.2 Configuring ICMP Test Parameters
This part describes how to set ICMP test parameters.
Context
Do as follows on the NQA client:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
test-type icmp
The test type is set to ICMP.
Step 4 Run:
destination-address ipv4 ip-address
The destination IP address is configured.
Step 5 (Optional) Perform the following as required to configure other ICMP test parameters:
l To configure the VPN instance to be tested, run the vpn-instance vpn-instance-name
l To configure the source interface that sends test packets, run the source-interface interface-
l To configure the source IP address, run the source-address ipv4 ip-address command.
Issue 03 (2010-09-20)
Data
Administrator name and test name of the NQA test
Destination IP address
(Optional) Virtual Private Network (VPN) instance name, source interface that sends
test packets, source IP address, size of the Echo-Request packets, TTL value, ToS,
padding character, interval for sending test packets, and percentage of the failed NQA
tests
Start mode and end mode
command.
type interface-number command.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
6-9