Huawei Quidway S9300 Configuration Manual - Network Management page 566

8 HGMP Configuration
After the previous configuration, you can find that the interface on the administrator switch is
in the Up state.
[HUAWEI_0.Administrator-1] display interface Vlanif 10
Vlanif10 current state : UP
Line protocol current state : UP
Last line protocol up time : 2008-09-25 21:25:52
Description:HUAWEI, Quidway Series, Vlanif10 Interface
Route Port,The Maximum Transmit Unit is 1500
Internet Address is 1.0.0.1/8
Internet Address is 10.0.0.1/8 Cluster
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 0001-0001-0001
Last 300 seconds input rate 0 bits/sec, 0 packets/sec
Last 300 seconds output rate 0 bits/sec, 0 packets/sec
Input:
Output:
Step 8 Configure a static route on the administrator switch.
# This operation is to ensure that a reachable route exists between switches in the cluster and
servers or hosts.
[HUAWEI_0.Administrator-1] ip route-static 0.0.0.0 0 1.0.0.2
Step 9 Configure public servers and hosts of the cluster.
# Configure an FTP server.
[HUAWEI_0.Administrator-1] cluster
[HUAWEI_0.Administrator-1-cluster] cluster-ftp-nat enable
[HUAWEI_0.Administrator-1-cluster] ftp-server 2.0.0.1
# Configure a SFTP server.
[HUAWEI_0.Administrator-1-cluster] sftp-server 2.0.0.2
# Configure a Simple Network Management Protocol (SNMP) host.
[HUAWEI_0.Administrator-1-cluster] snmp-host 3.0.0.1
# Configure a log host.
[HUAWEI_0.Administrator-1-cluster] logging-host 4.0.0.1
After the previous configuration, check information about the cluster to which the administrator
switch belongs. You can find that the public log host, SNMP host, FTP server, and SFTP server
are configured successfully.
[HUAWEI_0.Administrator-1-cluster] display cluster
Cluster name:"HUAWEI"
Role:Administrator switch
management vlan id
Cluster multicast MAC address : 0180-c200-000a(default)
Cluster auto-join
Handshake timer:10 sec
Handshake hold-time:60 sec
IP pool:10.0.0.1/8
Logging host:4.0.0.1
SNMP host:3.0.0.1
FTP server:2.0.0.1
SFTP server:2.0.0.2
cluster-member ftp-timeout: 300 sec(default)
8-70
0 packets, 0 bytes
0 packets, 0 bytes
Input bandwidth utilization
Output bandwidth utilization : --
NOTE
You can also run a routing protocol.
: 10
: disabled
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
: --
Issue 03 (2010-09-20)