Huawei Quidway S9300 Configuration Manual - Network Management page 519
Terabit routing switch
Hide thumbs
Also See for Quidway S9300:
- Configuration manual (603 pages) ,
- Configuration manual - multicast (262 pages) ,
- Hardware description (224 pages)
Table of Contents
Advertisement
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
l
Issue 03 (2010-09-20)
2.
Run:
cluster
The cluster view is displayed.
3.
Run:
port-tagged vlan
Communication interfaces in the cluster are added to the management VLAN in trunk
mode.
Configure public servers and hosts.
Do as follows on the administrator switch:
1.
Run:
system-view
The system view is displayed.
2.
Run:
cluster
The cluster view is displayed.
3.
Run:
ftp-server ip-address
A public FTP server is configured for the cluster.
NOTE
The member switches in a cluster can communicate with the FTP server in either of the
following modes:
l Non-NAT: There must be reachable routes between member switches and FTP server.
l NAT: The cluster-ftp-nat enable command must be run in the cluster view to enable the
FTP NAT function on the administrator switch. The NAT rules are automatically generated
on the administrator switch, and the member switches obtain the NAT mapped ports.
The FTP NAT function on the administrator switch is disabled by default. That is, the member
switches communicate with the FTP server in non-NAT mode.
After the FTP server for the cluster is configured successfully, you can run the cluster-ftp
command so that the member switches can access the FTP server.
4.
Run:
sftp-server ip-address
A public SFTP server is configured for the cluster.
5.
Run:
snmp-host ip-address
A public SNMP host is configured for the cluster.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 HGMP Configuration
8-23
Advertisement
Table of Contents
