Commands In The Global Configuration Mode - Siemens SCALANCE XC-200 Configuration Manual

Configuration
3.1 System
The parameters have the following meaning:
Parameter
destination-
address
size
byte
count
packet_count
timeout
seconds
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you do not select any parameters from the parameter list, the default values are used.
At system start or when using the restart command with the option memoryor factory,
the following defaults apply:
Parameter
size
count
timeout
Result
The messages relating to the response of the called node are displayed.
3.1.9

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
64
Description
Address of the called node
Keyword for the size of the packets to be
transferred
Keyword for the size of the packets in bytes 0 ... 2080
Keyword for the number of packets to be re‐
quested
Number of packets
Response wait time
If this time expires, the request is reported
as "timed out".
Time to the timeout in seconds
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values/note
Enter a valid IPv4 address or a valid
host name.
-
-
1 ... 10
-
1 ... 100
Default value
32
3
1
Configuration Manual, 07/2017, C79000-G8976-C361-06