Show Ip Igmp Snooping Switch-Ip; Commands In The Global Configuration Mode - Siemens SCALANCE XC-200 Configuration Manual

Result
The statistical information is displayed.
8.2.1.7

show ip igmp snooping switch-ip

Description
This command shows the IP address of the source for IGMP snooping.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show ip igmp snooping switch-ip
Result
The IP address is displayed.
8.2.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Layer 2 management protocols
8.2 IGMP snooping
379