Show Unicast-Block Config - Siemens SCALANCE XC-200 Configuration Manual

Syntax
Call up the command with the following parameters:
show broadcast-block config [port <interface-type> <interface-id)>]
The parameters have the following meaning:
Parameter
port
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The broadcast blocking settings for ports are displayed.
3.1.1.15

show unicast-block config

Description
This command shows the unicast blocking settings for ports.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show unicast-block config [port <interface-type> <interface-id)>]
The parameters have the following meaning:
Parameter
port
interface-type
interface-id
For information on names of interfaces and addresses, refer to the section "Addresses and
interface names (Page 36)".
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Keyword for a port description
Type or speed of the interface
Module no. and port no. of the interface
Description
Keyword for a port description
Type or speed of the interface
Module no. and port no. of the interface
Configuration
3.1 System
Range of values / note
-
Enter a valid interface.
Range of values / note
-
Enter a valid interface
57