No Ip Dhcp Config-File-Request; Ip Dhcp Client Mode - Siemens SCALANCE XC-200 Configuration Manual

Network protocols
7.2 DHCP client
Further notes
You disable the DHCP config file request option with the no ip dhcp config-file-
request command.
7.2.2.2

no ip dhcp config-file-request

Description
With this command, you disable the DHCP config file request option.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ip dhcp config-file-request
Result
The DHCP config file request option is disabled.
Further notes
You enable the DHCP config file request option with the ip dhcp config-file-
request command.
7.2.2.3

ip dhcp client mode

Description
With this command, you configure the type of identifier with which the DHCP client logs on
with its DHCP server.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
284
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06