Table of Contents
Advertisement
3.3.7. Inspection, balancing device
General
Several points are to be checked on the balancing device during the inspection. This section
details how to perform the inspection regarding:
Action at detected faults
If any faults are detected during the inspection, a maintenance may be performed according
to specific maintenance kits.
If the balancing device is an older model, it must in some cases be upgraded instead! The
instruction for the current inspection details if a fault requires a maintenance / upgrade and
the table below specifies the different models and which of the two actions they require.
The article number of the balancing device is located on a label at the rear cover, shown in
the figure
Balancing device, art. no.
3HAC10538-1
3HAC14675-1
3HAC022033-001 Revision: E
•
dissonance
•
damage
•
leakage
•
contamination / lack of free space.
Inspection points, balancing device on page
3 Maintenance
3.3.7. Inspection, balancing device
154.
Action at detected faults
Upgrade
Maintenance
Continues on next page
153
Advertisement
Table of Contents
