Table of Contents
Advertisement
4 Repair
4.7.6. Replacement of gearbox, axis 6
Continued
10. Recalibrate the robot.
11.
370
Action
7. If the robot is going to work in a water jet
application cell:
•
apply Mercasol 3106 on unpainted
surfaces between gearbox and
turning disk
•
apply Mercasol 3106 on the screw
heads in the front of the turning
disk.
8. Perform a leak-down test.
9. Refill the gearbox with oil.
DANGER!
Make sure all safety requirements are met
when performing the first test run. These
are further detailed in section
First test run may cause injury or damage!
on page
36.
Note
xx0600003143
•
A: Unpainted surface between
gearbox and turning disk
•
B: Screw heads
Detailed in section
test on page
Detailed in section
6 on page
198.
Calibration is detailed in a separate
calibration manual, enclosed with the
calibration tools.
General calibration information is included
in section
Calibration information on page
371.
DANGER -
Performing a leak-down
216.
Filling, oil, gearbox axis
3HAC022033-001 Revision: E
Advertisement
Table of Contents
