Table of Contents
Advertisement
Refitting, motor axis 1
The procedure below details how to refit motor, axis 1.
3HAC022033-001 Revision: E
Action
3. Remove the cable gland cover at the cable exit by
unscrewing its two attachment screws.
NOTE!
Make sure the gasket is not damaged!
4. Disconnect all connectors beneath the motor cover.
5. Apply lifting tool, motor axis 1, 4, 5 to the motor.
6. In order to release the brakes, connect the 24 VDC
power supply.
7. Remove the motor by unscrewing its four
attachment screws and plain washers.
If required, use the extension 300mm for bits 1/2".
8. If required, press the motor out of position by fitting
removal tool, motor to the motor attachment screw
holes.
9.
CAUTION!
The motor weighs 32 kg! All lifting equipment used
must be sized accordingly!
10. Lift the motor to get the pinion away from the gear
and disconnect the brake release voltage.
11. Remove the motor by gently lifting it straight up.
Action
1.
DANGER!
Turn off all electric power, hydraulic and pneumatic
pressure supplies to the robot!
For Foundry Prime robots: Do not turn off the air
pressure to motors and SMB.
4.6.1. Replacement of motor, axis 1
Note
xx0200000199
•
A: Cable gland cover
Art. no. is specified in
equipment on page
297.
Connect to connector R2.MP1
•
+: pin 2
•
-: pin 5
Shown in the figure
Location of
motor on page
297.
Art. no. is specified in
equipment on page
297.
Art. no. is specified in
equipment on page
297.
Always use the removal tools in
pairs!
Note
Continues on next page
4 Repair
Continued
Required
Required
Required
299
Advertisement
Table of Contents
