Table of Contents
Advertisement
4 Repair
4.3.1. Replacement of cable harness, axes 1-4
Continued
10. Secure the SMB cover with its attachment screws.
11.
12. Pull the cable harness through the lower arm.
13. Refit the cable gland securing the cables inside
14. Refit the cable gland securing the cables to the
228
Action
9. Reconnect connectors R2.SMB, R1.SMB1-3,
R1.SMB4-6 to the SMB unit.
Reconnect X8, X9 and X10 if the brake release
board is located in frame.
Reconnect R1.G if it has been disconnected.
WARNING!
Before continuing any service work, please
observe the safety information in section
WARNING - The brake release buttons may be
jammed after service work on page
the lower arm.
arm house.
Make sure not to twist the harness!
Note
xx0200000118
37!
xx0100000142
xx0100000143
3HAC022033-001 Revision: E
Continues on next page
Advertisement
Table of Contents
