Table of Contents
Advertisement
3HAC022033-001 Revision: E
Action
6. Make sure the o-ring is fitted to the rear of the
gearbox. Lightly grease the o-ring.
7. Lift the gearbox to its mounting position.
8. Fit the gearbox onto the guide pins and slide it into
position.
9. Remove the lifting tool.
10. In a similar way, fit the lifting tool to the motor
flange. Lock the tool with the hook.
Lift it and slide it onto the guide pins.
Remove the lifting tool.
11. Insert and secure 18 of the 20 attachment screws
on the front of the motor attachment.
Remove the guide pins and tighten the remaining
two screws.
12. Remove the guide pins and tighten the remaining
two screws as above.
4.7.2. Replacement of gearbox, axis 2
Note
Art. no. is specified in
equipment on page
xx0100000136
A. O-ring, gearbox, axis 2
Make sure the gearbox is seated
properly!
Tightening torque: 300 Nm.
Reused screws may be used,
providing they are lubricated as
detailed in section
Screw joints on
page 390
before fitting.
Continues on next page
4 Repair
Continued
Required
342.
347
Advertisement
Table of Contents
