Igmp Enable - H3C s3600 series Command Manual

Value of maximum query response time for
IGMP(in seconds): 10
Value of robust count for IGMP: 2
Value of startup query interval for IGMP(in
seconds): 15
Value of last member query interval for IGMP(in
seconds): 1
Value of query timeout for IGMP version 1(in
seconds): 400
Policy to accept IGMP reports: none
Querier for IGMP: 10.1.0.5 (this router)
IGMP group limit: 256
Total 1 IGMP group reported

igmp enable

Syntax
igmp enable
undo igmp enable
View
Interface view
Parameters
None
Description
Use the igmp enable command to enable IGMP on an interface.
Use the undo igmp enable command to disable IGMP on an interface.
By default, IGMP is disabled on an interface. .
These commands do not take effect until the multicast routing feature is enabled. You need to use this
command before you can configure other IGMP features.
Related commands: multicast routing-enable.
Examples
# Enable IGMP on VLAN-interface 10.
Field
2-3
Description
The maximum response time for IGMP general
queries is 10 seconds (default).
The IGMP robustness variable is 2 (default).
The IGMP startup query interval is 15 seconds
(default).
The IGMP last member query interval is 1 second
(default).
The query timeout time for IGMPv1 is 400
seconds (default).
IGMP multicast group filtering policy for
controlling the access to multicast groups.
"None" means no filtering policy is applied;
otherwise, the applied policy is displayed. For
example, "acl 2000, only for IGMP version 1"
means ACL 2000 is applied only on IGMPv1
reports.
The IGMP querier address is 10.1.0.5 (this
device).
The maximum number of IGMP multicast groups
that can be joined on the VLAN interface is 256.
Total number of IGMP multicast groups on the
interface is 1.