H3C s3600 series Command Manual page 69

Parameters
vlan-id1: Specifies the ID of a VLAN of which information is to be displayed, in the range of 1 to 4094.
to vlan-id2: In conjunction with vlan-id1, define a VLAN range to display information about all existing
VLANs in the range. The vlan-id2 argument takes a value in the range of 1 to 4094, and must not be
less than that of vlan-id1.
all: Displays information about all the VLANs.
dynamic: Displays the number of dynamic VLANs and the ID of each dynamic VLAN. Dynamic VLANs
refer to VLANs that are generated through GVRP or those distributed by a RADIUS server.
static: Displays the number of static VLANs and the ID of each static VLAN. Static VLANs refer to
VLANs manually created.
Description
Use the display vlan command to display information about VLANs. The output shows the ID, type,
VLAN interface state and member ports of a VLAN.
If no keyword or argument is specified, the command displays the number of existing VLANs in the
system and the ID of each VLAN.
Related commands: vlan.
Examples
# Display information about VLAN 1.
<Sysname> display vlan 1
VLAN ID: 1
VLAN Type: static
Route Interface: configured
IP Address: 192.168.0.39
Subnet Mask: 255.255.255.0
Description: VLAN 0001
Name: VLAN 0001
Tagged Ports:
Ethernet1/0/1
Untagged Ports:
Ethernet1/0/2
Table 1-2 Description on the fields of the display vlan command
Field
VLAN ID
VLAN Type
Route Interface
IP Address
Subnet Mask
VLAN ID.
VLAN type (dynamic or static).
Indicates whether the VLAN interface of the VLAN is configured
with an IP address for routing.
Primary IP address of the VLAN interface (available only on a
VLAN interface configured with an IP address). You can use the
display interface vlan-interface command in any view or the
display this command in VLAN interface view to display its
secondary IP address(es), if any.
Subnet mask of the IP address of the VLAN interface.
1-4
Description