Host-Route - H3C s3600 series Command Manual

Description
Use the filter-policy gateway command to enable RIP to filter the routing information advertised by a
specified address.
Use the undo filter-policy gateway command to disable RIP from filtering the routing information
advertised by a specified address.
Use the filter-policy import command to enable RIP to filter the incoming routing information.
Use the undo filter-policy import command to disable RIP from filtering the incoming routing
information.
By default, RIP does not filter the received routing information.
Related commands: acl, filter-policy export, ip ip-prefix.
For details about ACL, refer to ACL Operation.
Examples
# Apply ACL 2000 to filter the incoming routing information.
<Sysname>system-view
System View: return to User View with Ctrl+Z.
[Sysname] rip
[Sysname-rip] filter-policy 2000 import

host-route

Syntax
host-route
undo host-route
View
RIP view
Parameters
None
Description
Use the host-route command to enable RIP to receive host routes.
Use the undo host-route command to disable RIP from receiving host routes.
By default, RIP is enabled to receive host routes.
In some special cases, RIP receives a great number of host routes from the same network segment.
These routes are of little help to addressing but occupy a lot of resources. In this case, the undo
host-route command can be used to disable RIP from receiving host routes to save network resources.
Examples
# Disable RIP from receiving host routes.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] rip
3-7