Display Rip Routing - H3C s3600 series Command Manual

Description
Use the display rip interface command to display RIP interface information.
Examples
# Display RIP interface information.
<Sysname> display rip interface
Address Interface
1.0.0.1 Vlan-interface100
Table 3-2 Description on the fields of the display rip interface command
Field
Address
Interface
Ver
MetrIn/Out
Input
Output
Split-horizon

display rip routing

Syntax
display rip routing
View
Any view
Parameters
None
Description
Use the display rip routing command to display RIP routing information.
Examples
# Display the information of the RIP routing table.
<Sysname> display rip routing
RIP Interface: public net
Ver MetrIn/Out Input Output
2 0/1
IP address of the interface running RIP (You need to use the network
command to enable the network segment on which the address resides.)
Name of the interface running RIP. The IP address of the interface
corresponds to that in the Address field.
Version of RIP running on the interface
Additional metric added when a route is received/sent
Indicates whether to allow the interface to receive RIP packets (on means
yes; off means no).
Indicates whether to allow the interface to send RIP packets (on means
yes; off means no).
Indicates whether split horizon is enabled (on means yes; off means no)
RIP routing table: public net
3-4
Split-horizon
on on on
Description