Display Qos-Interface Traffic-Priority - H3C s3600 series Command Manual

unit-id: Unit ID of the switch whose traffic policing configuration is to be displayed. For the value range
for the unit-id argument, refer to
Description
Use the display qos-interface traffic-limit command to display the traffic policing configuration of a
port or a unit.
Related commands: traffic-limit.
Examples
# Display the traffic policing configuration of Ethernet 1/0/1.
<Sysname> display qos-interface Ethernet1/0/1 traffic-limit
Ethernet1/0/1: traffic-limit
Inbound:
Matches: Acl 3000 rule 1
Effect mode: Union effect
Egress port: Ethernet1/0/2
Target rate: 640 Kbps
Burst bucket size: 16 Kbyte
Exceed action: remark-dscp cs7
Refer to Table 1-3

display qos-interface traffic-priority

Syntax
display qos-interface { interface-type interface-number | unit-id } traffic-priority
View
Any view
Parameters
interface-type interface-number: Specifies the type and number of a port for which priority marking
configuration is to be displayed.
unit-id: Unit ID of the switch whose priority marking configuration is to be displayed. For the value range
for the unit-id argument, refer to
Description
Use the display qos-interface traffic-priority command to display the priority marking configuration of
a port or a unit.
Related commands: traffic-priority.
Examples
# Display the priority marking configuration of Ethernet 1/0/1.
<Sysname> display qos-interface Ethernet1/0/1 traffic-priority
Ethernet1/0/1: traffic-priority
Inbound:
Table 1-2.
running
for the description on the output fields.
Table 1-2.
1-8