H3C s3600 series Command Manual page 56

Parameters
unit unit-id: Specifies the unit ID of a switch. With this keyword-argument combination specified, this
command can display the initial configuration file of the specified unit.
by-linenum: Displays configuration information with line numbers.
Description
Use the display saved-configuration command to display the initial configuration file of a switch.
Note that:
If the switch starts up without a configuration file, the system will display that no configuration file
exists upon execution of the command.
If you have saved configuration after the switch starts up, the command displays the last saved
configuration.
Related commands: save, reset saved-configuration, display current-configuration.
Examples
# Display the initial configuration file of the current switch.
<Sysname> display saved-configuration
#
sysname Sysname
#
gvrp
#
MAC-authentication
#
vlan 1
#
interface Vlan-interface1
ip address 192.168.0.36 255.255.255.0
#LOCCFG. MUST NOT DELETE
#
interface Aux1/0/0
#
interface Ethernet1/0/1
priority 7
webcache address 1.1.1.1 mac 0000-0000-0001 vlan 1
traffic-limit inbound ip-group 3001 rule 1 640 exceed remark-dscp 4
traffic-priority inbound ip-group 2000 rule 0 dscp ef
line-rate inbound 128
#
interface Ethernet1/0/2
voice vlan enable
#
interface Ethernet1/0/3
port link-type hybrid
port hybrid vlan 1 3 untagged
voice vlan enable
1-7