Udp-Helper Enable - H3C s3600 series Command Manual

View
User view
Parameters
None
Description
Use the reset udp-helper packet command to clear UDP Helper statistics.
Examples
# Clear UDP Helper statistics.
<Sysname> reset udp-helper packet

udp-helper enable

Syntax
udp-helper enable
undo udp-helper enable
View
System view
Parameters
None
Description
Use the udp-helper enable command to enable UDP Helper function. After this function is enabled, the
switch converts broadcasts containing the specified port numbers into unicasts and forwards them to
the destination server.
Use the undo udp-helper enable command to disable UDP Helper function.
By default, UDP Helper is disabled.
Note that: On an S3600 Series Ethernet Switch, the reception of directed broadcast packets to a directly
connected network is disabled by default. As a result, UDP Helper is available only when the ip
forward-broadcast command is configured in system view. For details about the ip
forward-broadcast command, refer to the IP Address and Performance part of this manual.
Examples
# Enable UDP Helper.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] udp-helper enable
1-2