Timer Quiet - H3C s3600 series Command Manual

By default, the response timeout time of RADIUS servers is 3 seconds.
Note that:
After sending out a RADIUS request (authentication/authorization request or accounting request)
to a RADIUS server, the switch waits for a response from the server. The maximum time that the
switch can wait for the response is called the response timeout time of RADIUS servers, and the
corresponding timer in the switch system is called the response timeout timer of RADIUS servers.
You can use the timer command to set the timeout time of this timer, and if the switch gets no
answer before the response timeout timer expires, it needs to retransmit the request to ensure that
the user can obtain RADIUS service.
Appropriately setting the timeout time of this timer according to your network situation can improve
the performance of your system.
The timer command has the same function with the timer response-timeout command.
Related commands: radius scheme, retry.
Examples
# Set the timeout time of the response timeout timer for RADIUS scheme radius1 to 5 seconds.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] radius scheme radius1
New Radius scheme
[Sysname-radius-radius1] timer 5

timer quiet

Syntax
timer quiet minutes
undo timer quiet
View
RADIUS scheme view
Parameters
minutes: Wait time before primary server state restoration, ranging from 1 to 255 minutes.
Description
Use the timer quiet command to set the time that the switch waits before it tries to re-communicate with
the primary server and restore the status of the primary server to active.
Use the undo timer quiet command to restore the default wait time.
By default, the switch waits five minutes.
Related commands: display radius scheme.
Examples
# Configure the switch to wait 10 minutes before it tries to restore the status of the primary server to
active.
<Sysname> system-view
1-52