H3C s3600 series Command Manual page 873

Port peak power
Port average power
Port current
Port voltage
Table 1-1 display poe interface command output description
Field
Port power enabled
Port power ON/OFF
Port power status
Port power mode
Port PD class
Port power priority
Port max power
Port current power
Port average power
Port peak power
Port current
Port voltage
# Display the PoE status of all ports.
<Sysname> display poe interface
PORT INDEX
Ethernet1/0/1
Ethernet1/0/2
Ethernet1/0/3
Ethernet1/0/4
Ethernet1/0/5
Ethernet1/0/6
Ethernet1/0/7
Ethernet1/0/8
......
<Omitted>
:552 mW
:547 mW
:10 mA
:51 V
PoE is enabled on the port
The power on the port is on/off
PoE status on the port:
user command set port to off: PoE to the port is turned off by the
user
Standard PD was detected: A standard PD is detected
detection is in process: PDs are being detected
PoE mode on the port:
signal: PoE through the signal cable
Class of power to the PD
PoE priority of the port:
critical: The highest
high: High
low: Low
The maximum available power on the port
The current power on the port
The average power on the port
The peak power on the port
The current on the port
The voltage on the port
POWER ENABLE MODE
on enable signal
on enable signal
off enable signal
off enable signal
off enable signal
off enable signal
off enable signal
on enable signal
1-2
Description
PRIORITY STATUS
low Standard PD was detected
low Standard PD was detected
low detection is in process
low detection is in process
low detection is in process
low detection is in process
low detection is in process
critical Standard PD was detected