Reset Traffic-Statistic - H3C s3600 series Command Manual

The display queue-scheduler command cannot display the queue weights (or bandwidth values)
specified in Ethernet port view. To do that, use the display this command in the corresponding
port view or the display current-configuration interface command in any view. Note that the two
commands display the queue scheduling configuration only when the configuration of a port is
different from the global configuration.
Related commands: display queue-scheduler.
Examples
# Configure WRR as the queuing algorithm and set the weights of queues 0 through 7 to 2, 2, 4, 4, 6, 6,
8, and 8 globally in system view.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] queue-scheduler wrr 2 2 4 4 6 6 8 8
# Configure Ethernet 1/0/1 to adopt the WRR queue scheduling algorithm, setting the weights of queue
0 through queue 7 to 1, 2, 3, 4, 5, 6, 7, and 8.
[Sysname] interface Ethernet 1/0/1
[Sysname-Ethernet1/0/1] queue-scheduler wrr 1 2 3 4 5 6 7 8
# Display the global queue scheduling configuration.
[Sysname-Ethernet1/0/1] display queue-scheduler
Queue scheduling mode: weighted round robin
weight of queue 0: 2
weight of queue 1: 2
weight of queue 2: 4
weight of queue 3: 4
weight of queue 4: 6
weight of queue 5: 6
weight of queue 6: 8
weight of queue 7: 8
# Display the queue scheduling configuration on Ethernet 1/0/1.
[Sysname-Ethernet1/0/1] display this
#
interface Ethernet1/0/1
queue-scheduler wrr 1 2 3 4 5 6 7 8
#
return

reset traffic-statistic

Syntax
reset traffic-statistic inbound acl-rule
View
Ethernet port view
Parameters
inbound: Specifies to clear the statistics of the inbound packets on the port.
1-21