Igmp Host-Join - H3C s3600 series Command Manual

port ranges cannot exceed 10. For port types and port numbers, refer to the parameter description in
the "Port Basic Configuration" part in this manual.
Description
Use the igmp host-join port command to configure one or more ports under the current VLAN
interface as simulated member hosts to join the specified multicast group or source and group.
Use the undo igmp host-join port command to remove the specified port(s) as simulated member
hosts for the specified multicast group or source and group.
By default, simulated joining is disabled.
Unlike a static member port, a port configured as a simulated member host will age out like a dynamic
member port.
Related commands: igmp-snooping enable, multicast static-group interface, multicast
static-group vlan
Before configuring simulated joining, enable IGMP Snooping in the VLAN corresponding to the current
VLAN interface.
Examples
# Configure Ethernet 1/0/1 under VLAN-interface 10 as a simulated host member host to join multicast
group 225.0.0.1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] igmp-snooping enable
Enable IGMP-Snooping ok.
[Sysname] vlan 10
[Sysname-vlan10] igmp-snooping enable
[Sysname-vlan10] quit
[Sysname] interface Vlan-interface 10
[Sysname-Vlan-interface10] igmp host-join 225.0.0.1 port Ethernet 1/0/1

igmp host-join

Syntax
igmp host-join group-address [source-ip source-address] vlan vlan-id
undo igmp host-join group-address [source-ip source-address] vlan vlan-id
View
Ethernet port view
Parameters
group-address: Address of the multicast group to join.
5-16