Display Vlan; Ip Address And Performance - H3C s3600 series Command Manual

Table 1-1 Description on the fields of the display interface Vlan-interface command
Vlan-interface2 current state
Line protocol current state
IP Sending Frames' Format is
PKTFMT_ETHNT_2
Hardware address
Internet Address
10.1.1.1/24 Primary
1.1.2.1/24 Sub
Description
The Maximum Transmit Unit
For information about how to configure an IP address for a VLAN interface, refer to the description on
the ip address command in the IP Address and Performance Command part.

display vlan

Syntax
display vlan [ vlan-id1 [ to vlan-id2 ] | all | dynamic | static ]
View
Any view
Field
1-3
Description
The state of the VLAN interface, which can be
one of the following:
Administratively DOWN: This VLAN interface
has been manually disabled with the
shutdown command.
DOWN: The administrative state of this VLAN
interface is up, but its physical state is down.
It indicates that the VLAN corresponding to
this interface does not contain ports in up
state (possibly because the lines have failed).
UP: The administrative and physical states of
this VLAN interface are both up.
The link layer protocol state of the VLAN
interface, which can be one of the following:
DOWN: The protocol state of this VLAN
interface is down, usually because no IP
address is configured.
UP: The protocol state of this VLAN interface
is up.
Format of the frames sent from the VLAN
interface. PKTFMT_ETHNT 2 indicates that this
VLAN interface sends Ethernet II frames. Refer
to the VLAN configuration part in the
accompanied operation manual for information
about frame formats.
MAC address corresponding to the VLAN
interface
IP address corresponding to the VLAN interface
Primary IP address of this VLAN interface
Secondary IP address of this VLAN interface
Description string of the VLAN interface
Maximum transmission unit (MTU)