Reset Pim Neighbor - H3C s3600 series Command Manual

View
PIM view
Parameters
acl-number: Number of IP advanced ACL that defines the rule for filtering the source and group
addresses. The value ranges from 3000 to 3999. Only register messages that match the permit
statement can be accepted by the RP.
Description
Use the register-policy command to configure a rule for filtering register messages.
Use the undo register-policy command to remove a rule for filtering register messages.
By default, no rule for filtering register messages is configured.
Examples
# Configure a rule for filtering register messages on the RP to allow multicast sources in the range of
10.10.0.0/16 to send multicast data to multicast groups in the range of 225.1.0.0/16.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] acl number 3010
[Sysname-acl-adv-3010] rule permit ip source 10.10.0.0 0.0.255.255 destination 225.1.0.0
0.0.255.255
[Sysname-acl-adv-3010] quit
[Sysname] pim
[Sysname-pim] register-policy 3010

reset pim neighbor

Syntax
reset pim neighbor { all | { neighbor-address | interface interface-type interface-number } * }
View
User view
Parameters
all: Clears all PIM neighbors.
neighbor-address: Neighbor address.
interface interface-type interface-number: Specifies an interface by its type and number. With an
interface specified, the command clears PIM neighbors of the specified interface only.
Description
Use the reset pim neighbor command to clear the specified PIM neighbor, PIM neighbors on the
specified VLAN interface, or all PIM neighbors.
Related commands: display pim neighbor.
Examples
# Clear the PIM neighbor 25.5.4.3.
3-14