Resilient Arp Configuration Commands; Display Resilient-Arp - H3C s3600 series Command Manual

3

Resilient ARP Configuration Commands

The contents of this chapter are only applicable to the S3600-EI series among S3600 Series Ethernet
Switches.
Resilient ARP Configuration Commands

display resilient-arp

Syntax
display resilient-arp [ unit unit-id ]
View
Any view
Parameters
unit unit-id: Unit ID ranging from 1 to 8. If a switch belongs to a fabric, resilient ARP information on
specific devices in the fabric can be displayed. The unit-id argument specifies the number of a device
about which the resilient ARP information is to be displayed.
Description
Use the display resilient-arp command to display the Resilient ARP state information of each unit and
the VLAN interface that can transmit Resilient ARP packets.
If the unit-id argument is not specified, this command is to display the Resilient ARP state information of
all units. If the unit-id argument is specified, this command is to display the Resilient ARP state
information of the specified unit.
Examples
# Display the information about the Resilient ARP state of unit 1.
<Sysname> display resilient-arp unit 1
The state of unit 1 is: L3Master
The sending interface(s):
Vlan-interface1
Vlan-interface2
The above output information means that the current Resilient ARP state of unit 1 is L3Master, and
VLAN interfaces through which the Resilient ARP packets are sent are VLAN-interface 1 and
VLAN-interface 2.
3-1