Traffic-Redirect - H3C s3600 series Command Manual

Examples
# Set the 802.1p priority to 1 for the packets received on any ports in VLAN 2 and destined to MAC
address 000F-E200-1234.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] acl number 4000
[Sysname-acl-ethernetframe-4000] rule permit cos 3 dest 000f-e200-1234 ffff-ffff-ffff
[Sysname-acl-ethernetframe-4000] quit
[Sysname] traffic-priority vlan 2 inbound link-group 4000 cos 1

traffic-redirect

Syntax
traffic-redirect { inbound | outbound } acl-rule { cpu | { interface interface-type interface-number |
link-aggregation-group agg-id } [ untagged ] }
undo traffic-redirect { inbound | outbound } acl-rule
View
Ethernet port view
Parameters
inbound: Redirects inbound packets.
outbound: Redirects outbound packets.
acl-rule: ACL rules to be applied for traffic classification. This argument can be the combination of
multiple ACLs. For more information about this argument, refer to
ACL rules referenced must be those defined with the permit keyword.
cpu: Redirects the packets to the CPU.
interface interface-type interface-number: Specifies the target port, to which the packets are to be
redirected. The interface-type interface-number argument refers to the port type and port number.
link-aggregation-group agg-id: Specifies the aggregation group the traffic is to be redirected to. The
agg-id argument is the ID of an aggregation group, in the range 1 to 416.
untagged: Specifies to remove the outer VLAN tag of a packet after the packet is redirected to a port or
an aggregation group.
Description
Use the traffic-redirect command to configure traffic redirecting on a port.
Use the undo traffic-redirect command to remove the configuration from the port.
You can configure to redirect inbound or outbound packets matching a specified ACL rule on a port to
the CPU, the specified port, or the specified aggregation group.
Related commands: display qos-interface traffic-redirect.
Table 1-4
1-28
and Table 1-5. Note that the