Display Snmp-Agent Group - H3C s3600 series Command Manual

Table 1-1 display snmp-agent community command output description
Community name
Group name
Storage-type

display snmp-agent group

Syntax
display snmp-agent group [ group-name ]
View
Any view
Parameters
group-name: Name of the desired SNMP group, a string of 1 to 32 characters.
Description
Use the display snmp-agent group command to display the information about an SNMP group,
including group name, security mode, related views, and storage mode.
A group is used to define security mode and related views. Users in the same group have the common
attributes.
Security mode falls into three types: authPriv (authentication with privacy), authNoPriv (authentication
without privacy), noAuthNoPriv (no authentication no privacy).
Related views include: read MIB view, write MIB view, and MIB view in which traps can be sent.
For the configuration of an SNMP group, refer to the snmp-agent group command.
Field
1-3
Description
Community name
SNMPv1 and SNMPv2c use community name
authentication. A community name functions like
a password; it is used to restrict access between
the NMS and the agent.
Group name
If you use the snmp-agent community
command to configure a community name for
SNMPv1 or SNMPv2c, the group name is the
community name.
If you use the snmp-agent usm-user { v1 | v2c }
command to configure a username, the group
name is the group to which the user belongs, and
the corresponding community name has the
attribute of the group.
Storage type, which can be:
volatile: Information will be lost if the system
is rebooted
nonVolatile: Information will not be lost if the
system is rebooted
permanent: Modification is permitted, but
deletion is forbidden
readOnly: Read only, that is, no modification,
no deletion
other: Other storage types