Timer - H3C s3600 series Command Manual

View
RADIUS scheme view
Parameters
None
Description
Use the stop-accounting-buffer enable command to enable the switch to buffer the stop-accounting
requests that get no response.
Use the undo stop-accounting-buffer enable command to disable the switch from buffering the
stop-accounting requests that get no response.
By default, the switch is enabled to buffer the stop-accounting requests that get no response.
Stop-accounting requests are critical to billing and will eventually affect the charges; they are important
to both users and ISPs. Therefore, the switch should do its best to transmit them to RADIUS accounting
servers. When getting no response to such a request, the switch should first buffer the request on itself,
and then retransmit the request to the RADIUS accounting server until it gets a response, or the
maximum number of transmission attempts is reached (in this case, it discards the request).
Related commands:
stop-accounting-buffer.
Examples
# In RADIUS scheme radius1, enable the switch to buffer the stop-accounting requests that get no
response from the servers.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] radius scheme radius1
New Radius scheme
[Sysname-radius-radius1] stop-accounting-buffer enable

timer

Syntax
timer seconds
undo timer
View
RADIUS scheme view
Parameters
seconds: Response timeout time of RADIUS servers, ranging from 1 to 10 seconds.
Description
Use the timer command to set the response timeout time of RADIUS servers (that is, the timeout time
of the response timeout timer of RADIUS servers).
Use the undo timer command to restore the default response timeout timer of RADIUS servers.
reset stop-accounting-buffer,
1-51
radius scheme, display