H3C s3600 series Command Manual page 865

display cluster current-topology
Syntax
display cluster current-topology [ mac-address mac-address1 [ to-mac-address mac-address2 ] |
member-id member-id1 [ to-member-id member-id2 ] ]
View
Any view
Parameters
mac-address mac-address1: Displays the topology structure three layers above or below the node
specified by the MAC address. If to-mac-address is specified, mac-address1 is the start point of the
route in the specified route topology displayed.
to-mac-address mac-address2: Displays the topology structure of the route from mac-address1 to
mac-address2.
member-id member-id1: Displays the structure of the standard topology three layers above or below
the node specified by the member ID. If to-member-id is specified, member-id1 is the start point of the
route in the specified route topology displayed.
to-member-id member-id2: Displays the topology structure of the route from member-id1 to
member-id2.
Description
Use the display cluster current-topology command to display the topology of the current cluster.
If to-mac-address or to-member-id is not specified, the system displays the topology structure three
layers below the node specified by the MAC address or member ID.
If to-mac-address or to-member-id is specified, the system displays the topology structure of the route
between the two specified MAC addresses or two member IDs.
When you display the cluster topology information, the devices attached to the switch that is listed in the
backlist will not be displayed.
Examples
# Display the topology of the current cluster.
<aaa_0.Sysname> display cluster current-topology
--------------------------------------------------------------------
(PeerPort) ConnectFlag (NativePort) [SysName:DeviceMac]
--------------------------------------------------------------------
ConnectFlag:
<--> normal connect
???? lost device
--------------------------------------------------------------------
---> odd connect
++++ new device
1-42
**** in blacklist
-┤├- STP discarding