Super - H3C s3600 series Command Manual

<Sysname> display history-command
system-view
quit
display history-command

super

Syntax
super [ level ]
View
User view
Parameters
level: User level, in the range of 0 to 3.
Description
Use the super command to switch from the current user level to a specified level.
Executing this command without the level argument will switch the current user level to level 3 by
default.
Note that:
Users logged into the switch fall into four user levels, which correspond to the four command levels
respectively. Users at a specific level can only use the commands at the same level or lower levels.
You can switch between user levels after logging into a switch successfully. The high-to-low user
level switching is unlimited. However, the low-to-high user level switching requires the
corresponding authentication. The authentication mode can be set through the super
authentication-mode command.
For security purpose, the password entered is not displayed when you switch to another user level.
You will remain at the original user level if you have tried three times but failed to enter the correct
authentication information.
Related commands: super authentication-mode, super password.
Examples
# Switch from the current user level to user level 3, using super password authentication.
<Sysname> super 3
Password:
User privilege level is 3, and only those commands can be used
whose level is equal or less than this.
Privilege note: 0-VISIT, 1-MONITOR, 2-SYSTEM, 3-MANAGE
# Switch from the current user level to level 3, using HWTACACS authentication.
<Sysname> super 3
Username: user@system
Password:
User privilege level is 3, and only those commands can be used
whose level is equal or less than this.
Privilege note: 0-VISIT, 1-MONITOR, 2-SYSTEM, 3-MANAGE
1-4