Mirroring-Group; Mirroring-Group Mirroring-Port - H3C s3600 series Command Manual

mirroring-group

Syntax
mirroring-group group-id { local | remote-destination | remote-source }
undo mirroring-group { group-id | all | local | remote-destination | remote-source }
View
System view
Parameters
group-id: Number of a port mirroring group, in the range 1 to 20.
all: Specifies to remove all mirroring groups.
local: Specifies the mirroring group as a local port mirroring group.
remote-destination: Specifies the mirroring group as the destination mirroring group for remote port
mirroring.
remote-source: Specifies the mirroring group as the source mirroring group for remote port mirroring.
Description
Use the mirroring-group command to create a port mirroring group.
Use the undo mirroring-group command to remove a port mirroring group.
The mirroring group you created can take effect only after you configure other parameters for it.
Note that, an S3600-EI series Ethernet switch supports configuring only one destination port in local
port mirroring or one reflector port in remote port mirroring. That is, on an S3600-EI switch, there can be
only one effective local mirroring group or one effective remote source mirroring group. The two
mirroring groups cannot coexist.
Related commands: display mirroring-group.
This command is available only on S3600-EI series Ethernet switches.
Examples
# Create a port mirroring group on the local switch.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] mirroring-group 1 local

mirroring-group mirroring-port

Syntax
mirroring-group group-id mirroring-port mirroring-port-list { both | inbound | outbound }
undo mirroring-group group-id mirroring-port mirroring-port-list
1-4