H3C s3600 series Command Manual page 138

Broadcast MAX-pps: 500
Unicast MAX-ratio: 100%
Multicast MAX-ratio: 100%
Allow jumbo frame to pass
PVID: 1
Mdi type: auto
Port link-type: access
Tagged VLAN ID : none
Untagged VLAN ID : 1
Last 300 seconds input:
Last 300 seconds output:
Input(total): 0 packets, 0 bytes
0 broadcasts, 0 multicasts, 0 pauses
Input(normal): - packets, - bytes
- broadcasts, - multicasts, - pauses
Input: 0 input errors, 0 runts, 0 giants,
0 frame, - overruns, 0 aborts, 0 ignored, - parity errors
Output(total): 0 packets, 0 bytes
0 broadcasts, 0 multicasts, 0 pauses
Output(normal): - packets, - bytes
- broadcasts, - multicasts, - pauses
Output: 0 output errors,
0 aborts, 0 deferred, 0 collisions, 0 late collisions
0 lost carrier, - no carrier
Table 1-4 Description on the fields of the display interface command
Field
Ethernet1/0/1 current state
IP Sending Frames' Format
Hardware address
Media type
Port hardware type
100Mbps-speed mode, full-duplex mode
Link speed type is force link, link duplex
type is force link
Flow-control is enabled
The Maximum Frame Length
Broadcast MAX-ratio
Unicast MAX-ratio
Multicast MAX-ratio
Allow jumbo frame to pass
PVID
Mdi type
0 packets/sec 0 bytes/sec
0 packets/sec 0 bytes/sec
- throttles, 0 CRC
- underruns, - buffer failures
Current Ethernet port status: UP, DOWN or
ADMINISTRATIVELY DOWN
Ethernet frame format
Port hardware address
Media type
Port hardware type
Current speed mode and duplex mode
Link speed and duplex status ( force or
auto-negotiation)
Status of flow-control on the port
Maximum frame length allowed on the port
Broadcast suppression ratio on the port
Unknown unicast suppression ratio on the port
Multicast suppression ratio on the port
Whether Jumbo frame is allowed on the port.
Default VLAN ID of the port
Network cable type
1-8
Description