Rip Work - H3C s3600 series Command Manual

Table 3-4 Receive mode of RIP packets
RIP version
RIP-1
RIP-2 broadcast mode
RIP-2 multicast mode
Table 3-5 Send mode of RIP packets
RIP version
RIP-1
RIP-2 broadcast mode
RIP-2 multicast mode
Examples
# Run RIP-2 on the interface VLAN-interface 10 and send RIP packets in the broadcast mode.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Vlan-interface 10
[Sysname-Vlan-interface10] rip version 2 broadcast

rip work

Syntax
rip work
undo rip work
View
Interface view
Parameters
None
Description
Use the rip work command to enable the interface to receive and send RIP packets.
Use the undo rip work command to disable the interface from neither receiving nor sending RIP
packets.
By default, all interfaces except loopback interfaces are enabled to receive and send RIP packets.
The differences between the rip work, rip input, and rip output commands are as follows:
The rip work command controls the receiving and sending of RIP packets on an interface.
The rip input command controls only the receiving of RIP packets on an interface.
The rip output command controls only the sending of RIP packets on an interface.
RIP-1 broadcast
packet
√
√
—
RIP-1 broadcast
packet
√
—
—
3-17
RIP-2 broadcast
packet
√
√
—
RIP-2 broadcast
packet
—
√
—
RIP-2 multicast
packet
—
—
√
RIP-2 multicast
packet
—
—
√