Radius Scheme - H3C s3600 series Command Manual

Note that:
You can set the source IP address of outgoing RADIUS messages to avoid messages returned
from RADIUS server from being unable to reach their destination due to physical interface trouble.
It is recommended to use a Loopback interface address as the source IP address.
You can set only one source IP address by using this command. When you re-execute this
command again, the newly set source IP address will overwrite the old one.
Related commands: nas-ip.
Examples
# Set source address 129.10.10.1 for outgoing RADIUS messages.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] radius nas-ip 129.10.10.1

radius scheme

Syntax
radius scheme radius-scheme-name
undo radius scheme radius-scheme-name
View
System view
Parameters
radius-scheme-name: Name of the RADIUS scheme to be created, a string of up to 32 characters.
Description
Use the radius scheme command to create a RADIUS scheme and enter its view.
Use the undo radius scheme command to delete a specified RADIUS scheme.
By default, a RADIUS scheme named "system" has already been created in the system.
Note that:
All the attributes of RADIUS scheme "system" take the default values, which you can see by using
the display radius scheme command.
The RADIUS protocol configuration is performed on a RADIUS scheme basis. For each RADIUS
scheme, you should specify at least the IP addresses and UDP port numbers of the RADIUS
authentication/authorization and accounting servers, and the parameters required for the RADIUS
client to interact with the RADIUS servers. You should first create a RADIUS scheme and enter its
view before performing RADIUS protocol configurations.
A RADIUS scheme can be referenced by multiple ISP domains simultaneously.
The undo radius scheme command cannot delete the default RADIUS scheme. In addition, you
are not allowed to delete a RADIUS scheme which is being used by an online user.
Related commands: key, retry realtime-accounting, scheme, timer realtime-accounting,
stop-accounting-buffer enable, retry stop-accounting, server-type, state, user-name-format,
retry, display radius scheme, display radius statistics.
1-42