Dhcp Rate-Limit Enable - H3C s3600 series Command Manual

Examples
# Configure the DHCP traffic threshold to 100 pps for port Ethernet 1/0/11.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface ethernet 1/0/11
[Sysname-Ethernet1/0/11] dhcp rate-limit enable
[Sysname-Ethernet1/0/11] dhcp rate-limit 100

dhcp rate-limit enable

Syntax
dhcp rate-limit enable
undo dhcp rate-limit enable
View
Ethernet port view
Parameters
None
Description
Use the dhcp rate-limit enable command to enable the function to limit DHCP traffic for an Ethernet
port. You can use this command to limit the DHCP traffic passing through an Ethernet port. When the
number of DHCP packets received on the port per second exceeds the specified threshold (the default
value is 15 pps), the switch will discard the exceeding DHCP packets.
Use the undo dhcp rate-limit enable command to disable the function. You can use this command to
relieve the DHCP traffic limit configured on an Ethernet port.
By default, the function to limit DHCP traffic is disabled on an Ethernet port. That is, DHCP traffic
passing through an Ethernet port is not limited.
Examples
# Enable the function to limit DHCP traffic for Ethernet 1/0/11 port.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface ethernet 1/0/11
[Sysname-Ethernet1/0/11] dhcp rate-limit enable
4-3