Vlan - H3C s3600 series Command Manual

You can use the undo shutdown command to enable a VLAN interface when its related parameters
and protocols are configured. When a VLAN interface fails, you can use the shutdown command to
disable the interface, and then use the undo shutdown command to enable this interface again, which
may restore the interface.
Enabling or disabling a VLAN interface does not influence the state of the Ethernet ports belonging to
this VLAN.
Related commands: display interface Vlan-interface.
Examples
# Disable the VLAN-interface2.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Vlan-interface 2
[Sysname-Vlan-interface2] shutdown

vlan

Syntax
vlan { vlan-id1 [ to vlan-id2 ] | all }
undo vlan { vlan-id1 [ to vlan-id2 ] | all }
View
System view
Parameters
vlan-id1: Specifies the ID of the VLAN you want to create or remove, in the range of 1 to 4094.
to vlan-id2: In conjunction with vlan-id1, specify a VLAN ID range you want to create or remove. The
vlan-id2 argument takes a value in the range of 1 to 4094, and must not be less than that of vlan-id1.
all: Creates or removes all existing VLANs except those configured with other functions.
1-7