Display Qos-Interface Line-Rate - H3C s3600 series Command Manual

Field
Exceed action
Priority action
Redirected to
inprofile
outprofile
Mirrored to
Queue scheduling mode
Remark vlan

display qos-interface line-rate

Syntax
display qos-interface { interface-type interface-number | unit-id } line-rate
View
Any view
Parameters
interface-type interface-number: Specifies the type and number of the port, of which the line rate
configuration is to be displayed.
unit-id: Unit ID of the switch for which line rate configuration is to be displayed. For the value range for
the unit-id argument, refer to
Description
Use the display qos-interface line-rate command to display the line rate configuration of a port or the
ports on a unit.
Related commands: line-rate.
Examples
# Display the line rate configuration of Ethernet 1/0/1.
Action to take for exceeding packets:
drop: Drops the packets.
remark-dscp: Re-marks the DSCP precedence of the packets
and forwards the packets.
Priority marking action, which can be:
cos: Sets 802.1p precedence for packets.
dscp: Sets DSCP precedence for packets.
ip-precedence: Sets IP precedence for packets.
local-precedence: Sets local precedence for packets.
"interface" indicates that the packets are redirected to the port.
"cpu" indicates that the packets are redirected to the CPU.
"link-aggregation-group" indicates that the packets are redirected
to the aggregation group.
Statistics about the packets within the traffic limit
Statistics about the packets beyond the traffic limit
"monitor interface" indicates that the packets are duplicated to a
port.
"cpu" indicates that the packets are duplicated to the CPU.
Queue scheduling algorithm, which can be:
strict priority
weighted round robin (WRR)
weighted fair queuing (WFQ)
Target VLAN ID used in VLAN mapping
Table 1-2.
1-6
Description