Packet-Filter - H3C s3600 series Command Manual

# Display the configuration of the QoS profile applied to Ethernet 1/0/2, assuming that the QoS profile
has been applied to Ethernet 1/0/2 dynamically.
<H3C> display qos-profile interface Ethernet 1/0/2
User's qos-profile applied mode: port-based
User abc@net applied qos-profile: test, 3 actions
packet-filter inbound ip-group 2000 rule 0
traffic-limit inbound ip-group 3000 rule 0 64
traffic-priority inbound ip-group 4000 rule 0 cos controlled-load
Table 2-1 Description on the fields of the display qos-profile command
qos-profile: test, 3 actions
packet-filter inbound ip-group 2000 rule 0
traffic-limit inbound ip-group 3000 rule 0 64
traffic-priority inbound ip-group 4000 rule 0 cos
controlled-load
User abc@net applied qos-profile: test, 3 actions
User's qos-profile applied mode
Default applied qos-profile: test, 3 actions
User abc@net applied qos-profile: test, 3 actions

packet-filter

Syntax
packet-filter { inbound | outbound } acl-rule
undo packet-filter { inbound | outbound } acl-rule
View
QoS profile view
Field
2-3
Description
Name of the QoS profile and the number of
actions configured in the QoS profile.
Filter the inbound packets matching rule 0 of
ACL 2000.
Limit the rate of the inbound packets matching
rule 0 of ACL 3000 to 64 kbps.
Set the 802.1p precedence of the inbound
packets matching rule 0 of ACL 4000 to
controlled-load (that is, 802.1p precedence 0).
The QoS profile applied to 802.1x user abc@net
is named test and contains three actions.
The QoS profile is dynamically applied and the
application mode could be:
User-based, or
Port-based
For detailed information about the two
application modes, refer to the corresponding
operation manual.
"Default" indicates that the QoS profile named
test is applied to Ethernet 1/0/1 manually. The
QoS profile contains three actions.
The QoS profile test is applied to Ethernet 1/0/2,
the access port for 802.1x user abc@net. The
QoS profile contains three actions.