User Privilege Level - H3C s3600 series Command Manual

Description
Use the user-interface command to enter one or more user interface views to perform configuration.
Examples
# Enter VTY0 user interface.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface vty 0
[Sysname-ui-vty0]

user privilege level

Syntax
user privilege level level
undo user privilege level
View
User interface view
Parameters
level: Command level ranging from 0 to 3.
Description
Use the user privilege level command to configure the command level available to the users logging in
to the user interface.
Use the undo user privilege level command to revert to the default command level.
By default, the commands at level 3 are available to the users logging in to the AUX user interface. The
commands at level 0 are available to the users logging in to VTY user interfaces.
Commands fall into four command levels: visit, monitor, system, and manage, which are described as
follows:
Visit level: Commands at this level are used to diagnose network, such as the ping, tracert, and
telnet command. Commands at this level cannot be saved in configuration files.
Monitor level: Commands at this level are used to maintain the system, to debug service problems,
and so on. The display and debugging commands are at monitor level. Commands at this level
cannot be saved in configuration files.
System level: Commands at this level are used to configure services. Commands concerning
routing and network layers are at system level. You can utilize network services by using these
commands.
Manage level: Commands at this level are for the operation of the entire system and the system
supporting modules. Services are supported by these commands. Commands concerning file
system, file transfer protocol (FTP), trivial file transfer protocol (TFTP), downloading using
XModem, user management, and level setting are at administration level.
Refer to CLI Configuration for information about command level.
1-28