H3C s3600 series Command Manual page 837

Description
Use the administrator-address command to specify the management device MAC address and the
cluster name on a device to add the device to the cluster.
Use the undo administrator-address command to remove the management device MAC address
from the MAC address list of a member device, that is, remove the member device from the cluster.
Normally, this command is used for debugging and restoring purpose.
By default, a switch is not a member of any cluster.
A cluster has one and only one management device. Setting the management device MAC address on
a device can add the device to the cluster and enable the device to identify the management device
even if it restarts.
You can add a device to a cluster using the administrator-address command no matter whether the
super password of the device is consistent with that of the management device.
Normally it is recommended to use the delete-member command on the management device to
remove a member device from the cluster.
Examples
# Remove the current member device from the cluster.
<aaa_1.Sysname> system-view
System View: return to User View with Ctrl+Z
[aaa_1.Sysname] cluster
[aaa_1.Sysname-cluster] undo administrator-address
auto-build
Syntax
auto-build [ recover ]
View
Cluster view
Parameters
recover: Recovers all member devices.
Description
Use the auto-build command to start an automatic cluster building process.
You can execute this command on a management device or on a switch to be configured as a
management device.
When you execute this command on a candidate device, you are prompted to enter a cluster name to
build a cluster. The candidate device will automatically become the management device of the cluster.
Then, the management device will collect candidate devices and add them to the cluster automatically.
When you execute this command on a management device, the system directly collects candidate
devices ant automatically adds them to the cluster.
The recover keyword is used to recover a cluster. After you execute the auto-build recover command,
the system looks for the down members in the member list and add them to the cluster again.
1-14