H3C s3600 series Command Manual page 615

If you specify a VLAN interface only, the command will display the state information of all VRRP
groups on the specified VLAN interface.
If you specify both a VLAN interface and a VRRP group, the command will display the state
information of the specified VRRP group on the specified VLAN interface.
Examples
# Display the VRRP state information about all the VRRP groups on the switch.
<Sysname> display vrrp
Run Method
Virtual Ip Ping : Disable
The total number of the virtual routers:
Interface
--------------------------------------------------------------------------
Vlan2
Table 1-1 Description on the fields of the display vrrp command
Field
Run Method
Virtual IP ping
Interface
VRID
State
Run Pri
Adver. Timer
Auth Type
Virtual IP
# Display detailed information about all VRRP groups on the switch.
<Sysname> display vrrp verbose
Run Method
Virtual Ip Ping : Disable
Interface
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Virtual MAC
Master IP
: VIRTUAL-MAC
VRID State Run
Pri
2 Initialize 100
Current VRRP running method, including REAL-MAC and
VIRTUAL-MAC
Whether you can ping the virtual IP address of the VRRP group
Interface where the VRRP group resides
ID of the virtual router
Status of the current switch in the VRRP group, including Master,
Backup and Initialize
Running priority
Interval for sending VRRP advertisements
Authentication type, including NONE, SIMPLE, and MD5
Virtual IP address of the VRRP group
: VIRTUAL-MAC
: Vlan-interface1
: 1
: UP
: 100
: YES
: NONE
: 192.168.0.133
: 0000-5e00-0101
: 192.168.0.68
1
Adver. Auth Virtual
Time Type IP
1 NONE 173.160.0.1
Description
Adver. Timer : 1
State : Master
Run Pri : 100
Delay Time : 0
1-2