Reset Ndp Statistics; Ntdp Configuration Commands; Display Ntdp - H3C s3600 series Command Manual

reset ndp statistics

Syntax
reset ndp statistics [ interface interface-list ]
View
User view
Parameters
interface-list: Ethernet port list, in the format of { interface-type interface-number [ to interface-type
interface-number ] } &<1-10>, where to is used to specify a port range, and &<1-10> means that you
can provide up to ten port indexes/port index ranges for this argument. The interface-number argument
is in the format of unit ID/slot number/port number.
Description
Use the reset ndp statistics command to clear the NDP statistics on specific ports. When executing
the command, if you specify the interface keyword, the command will clear NDP statistics on the
specified ports; if you do not specify the interface keyword, the command will clear NDP statistics on all
ports.
You can use the display ndp command to view the NDP statistics before and after the execution of the
reset ndp statistics command to verify the execution result.
Examples
# Display the NDP statistics on port Ethernet 1/0/6.
<Sysname> display ndp interface ethernet 1/0/6
Interface: Ethernet1/0/6
Status: Enabled, Pkts Snd: 1, Pkts Rvd: 2, Pkts Err: 0
# Clear the NDP statistics on port Ethernet 1/0/6.
<Sysname> reset ndp statistics interface ethernet 1/0/6
# Re-display the NDP statistics on port Ethernet 1/0/6.
<Sysname> display ndp interface ethernet 1/0/6
Interface: Ethernet1/0/6
Status: Enabled, Pkts Snd: 0, Pkts Rvd: 0, Pkts Err: 0

NTDP Configuration Commands

display ntdp

Syntax
display ntdp
View
Any view
Parameters
None
1-5