ipv6 rip interface
Creates or deletes a RIPng interface.
ipv6 rip interface if_name
[no] ipv6 rip interface if_name
Syntax Definitions
if_name
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
By default, a RIPng interface is created in the enabled state.
•
Routing is enabled on a VLAN when you create a router port. However, to enable RIPng routing, you
must also configure and enable a RIPng routing interface on the VLAN's IP router port. For more
information on VLANs and router ports, see
•
RIPng will support a maximum of 20 interfaces.
Examples
-> ipv6 rip interface Test_Lab
Release History
Release 6.6.1; command was introduced.
page 30-74
IPv6 interface name.
Chapter 22, "VLAN Management
OmniSwitch 6250 CLI Reference Guide
IPv6 Commands
Commands".
November 2009