Table of Contents
Advertisement
Software Upgrades
Software Upgrades
VISM/VISM-PR Release 3.0 provides a graceful upgrade procedure for the following releases:.
•
•
•
Caution
Installing VISM software upgrades from VISM Release 2.2 with CALEA to VISM Release 3.0
without CALEA is not graceful.
Prerequisites
To ensure that the VISM/VISM-PR configuration is preserved throughout the upgrade procedure, you
must complete the prerequisites listed in this section.
Before starting the graceful upgrade procedure, complete the following prerequisites:
•
•
•
•
VISM/VISM-PR Upgrades with PXM1
This section describes the procedures for upgrading VISM/VISM-PR software when the
VISM/VISM-PR is used with a PXM1 card.
Download VISM/VISM-PR Boot Code and Firmware to PXM1
To download the VISM/VISM-PR boot code and firmware to the PXM1 card, use TFTP.
Log in to your TFTP server.
Step 1
Download the bootcode and firmware images from the Cisco website.
Step 2
Download the selected revision of service module boot code into the service module.
Step 3
a.
b.
c.
d.
Cisco VISM Installation and Configuration Guide
1-20
From VISM 1.5 to VISM 3.0
From VISM 2.1 to VISM 3.0
From VISM 2.2 to VISM 3.0
Configure your MGX 8000 Series shelf with at least two VISM cards in a redundant configuration.
For more information on adding redundancy, refer to the add redundancy, addred, command in the
Cisco MGX 8250, Cisco MGX 8230, and Cisco MGX 8850 PXM1-based Command Reference
documentation and the Cisco MGX 8830 and MGX 8850 PXM1E/ PXM45-based Command
Reference documentation.
Ensure that the VISM/VISM-PR cards are running at least Release 2.1.
Download software Release 3.0 for VISM/VISM-PR to the MGX 8000 Series shelf.
If you are using the CALEA feature, ensure that you have the version of VISM/VISM-PR software
that supports CALEA.
tftp <node_name or IP address>
bin
put <backup boot> POPEYE@SM_1_0.BT
quit
Chapter 1
Overview of the VISM and VISM-PR Cards
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Advertisement
Table of Contents
